Propshaft Balancing Machines
PBM7 Machine Specification
The PBM 7 Propshaft Balancing Machine has been designed specifically for the accurate dynamic balancing of most types of propshaft and is especially suited to one-off or small-batch applications.
Available for propshafts up to GWB 587.50 Series. Maximum Shaft Weight 240kgs.
Overall Length 400cm.
Optional Extra Bed Section 150cm.
Max.Height 150cm. Bed Height 90cm.
Weight before installation 420kg.
Micro processor controlled. Menu drives for single, twin and three piece drivelines. IBM compatible. Optional printout of results.
Fully adjustable for propshaft type and length.
Depending on specification. Inverter speed control to 4500 RPM with auto control.
220/240 volt A.C single phase. 50/60 Hz.
To G6.3 (BS 1970)
Full range of extra cradles, reverse sleeve and flange adaptors available
Additional equipment available on request
Propshaft (Cardan Shaft) Welding Machine
Complete with 350 Amp. MIG welding unit, 200m 3 jaw self-centring chucks (2).
Propshaft (Cardan Shaft) Welding Machine 15 tonnes Horizontal Letting-In Press
A reinforced version of above with foot control air over hydraulic pump activated press, spring return tailstock supplied complete with tube location blocks.
Horizontal Letting-In Press and Straightening Press
Equipped with a chain vice and 10 tonne hydraulic press controlled with a remote air over hydraulic foot pump.
55tonne Straightening Machine
Single-acting spring return press with remote control 220V pump, heavy duty RSJ bed, pressure tail-stock clamping, pneumatic raise and lower of product onto support tube blocks supplied with face plates (for adaptors) and range of tube supports.