Centre Bearing Assembly and Installation Tips

All of the centre bearings listed have rubber in their construction, which acts as a flexible and vibration isolating mounting of the drive shaft to the vehicle chassis / body. It is therefore important that the assembly is carefully and correctly carried out. When a centre bearing fails, damage to the drive shaft may result. This should be repaired as necessary after inspection.
bearing_tech_drawing1
Use correct diameter tube to press Flinger into place without damage or distortion.
bearing_tech_drawing2
Press centre bearing into position with suitable diameter tube pushing only through inner race of bearing.

Check that the centre bearing rotates freely when fully assembled to the drive shaft, and if possible check free rotation of driveshaft when installed in the vehicle.

Technical Data

From component part information to critical speed graphs it’s all covered here.

View the technical data

Meet The Team

Meet The Team

Russell's Rant

Our likeable Salesman always has an opinion about something!

View All

Latest Products

BRG.A25

AUDI A8 QUATTRO 4X4 2017 ON - OE REF 4N0 521 101

BRG.T17

NEW TOYOTA HILUX 4X2 AUTO 2015 ON - OE REF 37230-O9010

View all